Application guide

Two products, two techniques. Choose below what you want to apply and just follow the steps.

Press settings

Temperature140–145°CFor polyester/synthetics, 130-135°C should do. the trick.

How long? 10 secWhen in doubt, it's better to press a second time than to press more than 10 seconds on your first press.

Pressure3–4 barFirm and even, the adhesive must attach properly into the fibers.

Peeling methodHot peelRemove the film quickly while it's still warm, directly after pressing.

Pre-pressingNot neededMake sure the garment is dry and free of any wrinkles.

Final press10 secMakes the print softer, more matte and more durable.

Washing instructionsMax. 40°CWash inside out, without fabric softener, do not tumble dry. Wait 48 hours before doing the first wash.

Materials

Excellent for

Cotton & cotton blends
Polyester (sports wear/team wear)
Canvas & tote bags

Materials that need extra care when applying

Nylon: lower the temperature and test it before
Softshell: risk of dye migration. Always test upfront
Sublimated garments: risk of dye migration. Always test upfront.
Faux leather/PU: use a lower temperature and shorter press time. Always test upfront

Washing instructions

Wash at max. 40°C.
Wash inside out.
Do not use fabric softener.
Do not tumble dry.
Wait 48 hours before doing the first wash.

Troubleshooting

Transfer peeling off

Usually caused by too little pressure or removing the transfer too fast. Put the transfer back in place, increase the pressure and press again for 5–8 seconds.

Dull print

The final press was too long, or the temperature was too low. Shorten the final press time or increase the temperature slightly.

Silvering (grey haze)

Too little pressure or an uneven pressing surface. Use a flat, firm underlay and increase the pressure.

Printed incorrectly or crooked

Use heat-resistant tape to make sure the transfer stays in place, before pressing, especially for larger prints.

Pressed too cold

The adhesive does not fully melt into the fibre, so the print will eventually peel off. Check the temperature of your press with a thermometer.

Pressed too hot

The print feels stiff, cracks or discolours. Stick to 140–145°C and use a short final press rather than one long hot press.

Guidelines apply to our standard DTF transfers.

Would you like to test our transfers?

Request a free sample box and test our transfers.

Free sample box Check the FAQ